Jump to main content
Independent fitting bench · Jacksonville, FL Bays booked one at a time — call (904) 555-0118
Hold a Bay
Rates

What a Session Costs, Written Down

Session fees below are for the fitting itself. Components are always quoted separately, at what we pay plus a flat build charge, and you see both lines before anything is ordered.

Single Club

$120About 90 minutes
  • Hand and grip measurement
  • One club category, start to finish
  • Turf board work where relevant
  • Written build card
  • Ninety days of adjustments
Most Requested

Scoring Clubs

$210About 2.5 hours
  • All wedges plus the short irons above them
  • Bounce and grind selection on local turf
  • Groove condition assessment on current clubs
  • Gapping checked across the whole scoring set
  • Written build card and ninety-day adjustments

Whole Bag

$395Two visits
  • Driver through putter across two sessions
  • Full gapping map, not club-by-club guesses
  • Grip programme standardised across the bag
  • Written card per club
  • Six months of adjustments instead of ninety days

Session fees are credited in full against any build we carry out within sixty days.

Bench Work

Adjustments and Repairs, Priced by the Job

No fitting session required. Bring clubs in and we will quote before we start.

Prices are labour only. Grips, shafts, ferrules and adapters are billed at cost.
Bench Job Charge Turnaround
Regrip, per club$6Same day
Regrip with tape build-up to spec, per club$9Same day
Loft and lie adjustment, per club$81–2 days
Shaft pull and reinstall, per club$282–4 days
Length change with swing weight correction$322–4 days
Wedge sole relief work$453–5 days
Groove condition report, full wedge set$25Same day
Full set spec audit, written card$702–3 days
Broken shaft extraction$352–5 days
How Components Are Billed

Cost Plus a Flat Build Charge, Itemised

When a session ends in a build, you get two numbers. The first is what the components cost us, shown to you on the supplier line. The second is a flat build charge per club that covers cutting, boring, weighting, assembly, grip installation and the post-cure re-check.

We do not mark components up on a percentage, because a percentage mark-up quietly rewards recommending expensive parts. A flat charge does not.

  • Build charge, wood or hybrid: $30 per club
  • Build charge, iron or wedge: $24 per club
  • Build charge, putter: $34 per club
  • Components at documented supplier cost, always shown
Sample Invoice
SessionSingle club fitting — $120
HeadSupplier cost — $189
ShaftSupplier cost — $84
GripSupplier cost — $11
BuildFlat charge — $30
CreditSession fee applied — −$120

Every line is visible before you approve the order. There is no bundled "fitting package" price hiding the split.

Gift Certificates Work Too

Available for any session tier, valid for a year, and transferable. Ask Curtis when you call.

Rather talk it through than fill in a form? The bench phone rings straight to whoever is fitting that day.

(904) 555-0118